Skip to Content

Renofix 90 GRAY – BASIC PLASTER FOR PRELIMINARY TREATMENT AND INTERIOR FELT

To be used as a basic felt plaster for internal areas. It is not for use in wet/moist areas. For manual plastering one sack of Renofix 90 is mixed with 9 to 10 litres of clean water for approximately 2 minutes and then spread with sand. The Skure-Tech S4 is used for machine plastering and levelled using an aluminium leveller. Minimum thickness is 10 mm for the walls and 7 mm for ceilings. The minimum functional temperature is 5°C.

Technical Sheet

RENOFIX-90

READ MORE

Renofix 100 GRAY – INTERNAL PLASTER FOR COVERING AND LEVELLING

To be used as a basic sand plaster and sand layer for internal surfaces. It is not suitable for wet/moist surfaces. One sack Renofix 100 is mixed with 10 to 11 litres of pure clean water. The Skure-Tech S4 is used for machine plastering and levelling using an aluminium leveller. Minimum thickness is 10 mm for the walls and 7 mm for the ceilings. The minimum functional temperature is +5°C.

Technical Sheet

RENOFIX-100

READ MORE

Renofix 220 GRAY – LIGHT PLASTER FOR TREATMENT OF INTERNAL WALLS WITH PERLIT

Light layer of lime baseline for ceilings and internal concrete walls. One sack of Renofix 220 is poured into 10 to11 litres of water and is mixed. The Skure-Tech S4 is used for machine plastering afterwards levelling is required as is sanding. The thickness of the plaster should be 8 to 10 mm. The minimum functional temperature is 5°C. Do not mix with other materials. Store in a dry place.

Technical Sheet

RENOFIX-220

READ MORE